DIY with only 100 uniform materials on the PS controller stand

material

* All Daiso * Daiso * 400 × 9 × 150 mm 1 square bar 910 × 10 × 21 mm 1 alphabet object “X” 4 trees, saw bonds, saws for saws, stickers, etc.

Let's make it

Cut the square bar and make two 40 cm.This is the end of this cut ❗

Paint two square rods and plate materials with your favorite paint.When it is dry, attach one square bar to the plate material.Fix it with a woodworking bond.

Fix the other border from the edge to 2 cm position.Points to note here.In my case, it was 2 cm, but please adjust the size of the "X" sandwiched between the square bar and the square bar.

"X" requires attention in the direction.If the direction is different,

You can slip like an arrow.Please make everything together ☺️

Put on the bond

Insert it into 5 cm from the end.The bond will stick out, but it will be transparent when it dries, so it's okay.

Here, there is another thing to be aware of. Instead of inserting all, the other is small, so float it a little like a seal and fix it.This will make you parallel.

All were installed.

"X" is the first place in 5cm from the end.The second should be fixed at an interval of about 3 cm.Attach the other two from the other side in the same way.

Completion ❗

For the time being, it's completed, but it's more time than I thought ... it's not enough ... so

Ceria's tin petrification I had purchased before.

Painted with acrylic paint (gold, brown)

Painted the remaining scraps of the previous work

Combined with Glue Gun

I installed it here and filled the subtle gaps (laughs)

The sticker I put is Daiso ☺️

It was done ~ ＼ (^-^) / Wrap the cable ............. make it refreshing.

It was installed next to the TV. It's a good feeling to be familiar with my interior.Thank you for reading to the end.

Notice from Limia

If you are considering renovation, you can immediately see the local renovation cost by comparing "Hapi" ♡ ・ 3 companies!・ Service satisfaction 94%!Over 100,000 quotes requested!